Configuring Access Control Right - H3C S5100-SI Operation Manual

A multicast server can synchronize multicast clients only after its clock has been synchronized.
An S5100-SI/EI series switch working in the multicast server mode supports up to 1,024 multicast
clients.
Configuring a switch to work in the multicast server mode
Follow these steps to configure a switch to work in the NTP multicast server mode:
To do...
Enter system view
Enter VLAN interface view
Configure the switch to work in
the NTP multicast server mode
Configuring a switch to work in the multicast client mode
Follow these steps to configure a switch to work in the NTP multicast client mode:
To do...
Enter system view
Enter VLAN interface view
Configure the switch to work in
the NTP multicast client mode

Configuring Access Control Right

With the following command, you can configure the NTP service access-control right to the local switch
for a peer device. There are four access-control rights, as follows:
query: Control query right. This level of right permits the peer device to perform control query to the
NTP service on the local device but does not permit the peer device to synchronize its clock to the
local device. The so-called "control query" refers to query of state of the NTP service, including
alarm information, authentication status, clock source information, and so on.
synchronization: Synchronization right. This level of right permits the peer device to synchronize
its clock to the local switch but does not permit the peer device to perform control query.
server: Server right. This level of right permits the peer device to perform synchronization and
control query to the local switch but does not permit the local switch to synchronize its clock to the
peer device.
peer: Peer access. This level of right permits the peer device to perform synchronization and
control query to the local switch and also permits the local switch to synchronize its clock to the
peer device.
Use the command...
system-view
interface Vlan-interface vlan-id
ntp-service multicast-server
[ ip-address ] [ authentication-keyid
keyid | ttl ttl-number | version
number ]*
Use the command...
system-view
interface Vlan-interface
vlan-id
ntp-service multicast-client
[ ip-address ]
1-10
Remarks
—
—
Required
Not configured by default.
Remarks
—
—
Required
Not configured by default.