H3C S5100-SI Operation Manual page 753

Network diagram
Figure 1-10 Network diagram for the DNS test
Configuration procedure
Configure DNS Server:
Use Windows 2003 Server as the DNS server. For DNS server configuration, refer to the related
instruction on Windows 2003 Server configuration.
Configure HWPing Client (Switch A)
# Enable the HWPing client.
<Sysname> system-view
[Sysname] hwping-agent enable
# Create a HWPing test group, setting the administrator name to administrator and test tag to dns.
[Sysname] hwping administrator dns
# Configure the test type as dns.
[Sysname-hwping-administrator-dns] test-type dns
# Configure the IP address of the DNS server as 10.2.2.2.
[Sysname-hwping-administrator-dns] dns-server 10.2.2.2
# Configure to resolve the domain name www.test.com.
[Sysname-hwping-administrator-dns] dns resolve-target www.test.com
# Configure to make 10 probes per test.
[Sysname-hwping-administrator-dns] count 10
# Set the probe timeout time to 5 seconds.
[Sysname-hwping-administrator-dns] timeout 5
# Start the test.
[Sysname-hwping-administrator-dns] test-enable
# Display test results.
[Sysname-hwping-administrator-dns] display hwping results administrator dns
HWPing entry(admin administrator, tag dns) test result:
Destination ip address:10.2.2.2
Send operation times: 10
Min/Max/Average Round Trip Time: 6/10/8
Square-Sum of Round Trip Time: 756
Last complete test time: 2006-11-28 11:50:40.9
Extend result:
SD Maximal delay: 0
Packet lost in test: 0%
Receive response times: 10
DS Maximal delay: 0
1-30