To do...
Enable proxy checking
function globally
Enable proxy
checking for a
port/specified
ports
The proxy checking function needs the cooperation of H3C's 802.1x client (iNode)
program.
The proxy checking function depends on the online user handshaking function. To
enable the proxy detecting function, you need to enable the online user handshaking
function first.
The configuration listed in the above table takes effect only when it is performed on
CAMS as well as on the switch. In addition, the client version checking function needs
to be enabled on the switch too (by using the dot1x version-check command).
Configuring Client Version Checking
Follow these steps to configure client version checking:
To do...
Enter system view
Enable
802.1x
client
version
checking
Set the maximum
number of retires to
send version checking
request packets
Use the command...
dot1x
supp-proxy-check
{ logoff | trap }
dot1x
supp-proxy-check
In system
{ logoff | trap }
view
[ interface
interface-list ]
interface interface-type
interface-number
dot1x
In port view
supp-proxy-check
{ logoff | trap }
quit
Use the command...
system-view
In
dot1x version-check
system
[ interface interface-list ]
view
interface interface-type
interface-number
In port
view
dot1x version-check
quit
dot1x retry-version-max
max-retry-version-value
Required
By default, the 802.1x proxy
checking function is globally
disabled.
Required
By default, the 802.1x proxy
checking is disabled on a
port.
—
Required
By default, 802.1x client
version checking is disabled on
a port.
Optional
By default, the maximum
number of retires to send
version checking request
packets is 3.
1-18
Remarks
Remarks