Displaying The Device Management Configuration; Remote Switch App Upgrade Configuration Example - H3C S5100-SI Operation Manual

Displaying the Device Management Configuration

To do...
Display the APP to be adopted at
next startup
Display the module type and
operating status of each board
Display CPU usage of a switch
Display the operating status of the
fan
Display memory usage of a switch
Display the operating status of the
power supply
Display system diagnostic
information or save system
diagnostic information to a file with
the extension .diag into the Flash
memory
Display enabled debugging on a
specified switch

Remote Switch APP Upgrade Configuration Example

Network requirements
Telnet to the switch from a PC remotely and download applications from the FTP server to the Flash
memory of the switch. Update the switch software by using the device management commands through
CLI.
The switch acts as the FTP client, and the remote PC serves as both the configuration PC and the FTP
server.
Perform the following configuration on the FTP server.
Configure an FTP user, whose name is switch and password is hello. Authorize the user with the
read-write right on the directory Switch on the PC.
Make configuration so that the IP address of a VLAN interface on the switch is 1.1.1.1, the IP
address of the PC is 2.2.2.2, and the switch and the PC is reachable to each other.
The host software switch.bin and the Boot ROM file boot.btm of the switch are stored in the directory
switch on the PC. Use FTP to download the switch.bin and boot.btm files from the FTP server to the
switch.
Use the command...
display boot-loader [ unit unit-id ]
display device [ manuinfo | unit
unit-id ]
display cpu [ unit unit-id ]
display fan [ unit unit-id [ fan-id ] ]
display memory [ unit unit-id ]
display power [ unit unit-id
[ power-id ] ]
display diagnostic-information
display debugging { unit unit-id }
[ interface interface-type
interface-number ] [ module-name ]
4-5
Remarks
Available in any
view.