Setting To Output System Information To The Trap Buffer - H3C S5100-SI Operation Manual

To do...
Enter system view
Enable the information
center
Enable system
information output to a
log host
Configure the source
interface through which
log information is sent to
the log host
Configure the output
rules of system
information
Set the format of the time
stamp to be sent to the
log host
Be sure to set the correct IP address when using the info-center loghost command. A loopback IP
address will cause an error message prompting that this address is invalid.

Setting to Output System Information to the Trap Buffer

Follow these steps to set to output system information to the trap buffer:
To do...
Enter system view
Enable the information
center
Enable system information
output to the trap buffer
Use the command...
system-view
info-center enable
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
info-center loghost source
interface-type interface-number
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
info-center timestamp
loghost { date | no-year-date |
none }
Use the command...
system-view
info-center enable
info-center trapbuffer
[channel { channel-number |
channel-name } | size
buffersize]*
1-12
Remarks
—
Optional
Enabled by default.
Required
By default, the switch does not output
information to the log host.
After you configure the switch to
output information to the log host, the
switch uses information channel 2 by
default.
Optional
By default, no source interface is
configured, and the system
automatically selects an interface as
the source interface.
Optional
Refer to Table 1-4 for the default
output rules of system information.
Optional
By default, the time stamp format of
the information output to the log host
is date.
Remarks
—
Optional
Enabled by default.
Optional
By default, the switch uses
information channel 3 to output
trap information to the trap buffer,
which can holds up to 256 items by
default.