Configuring Radius Authentication/Authorization Servers; Configuring Ignorance Of Assigned Radius Authorization Attributes - H3C S5100-SI Operation Manual

Configuring RADIUS Authentication/Authorization Servers

Follow these steps to configure RADIUS authentication/authorization servers:
To do...
Enter system view
Create a RADIUS scheme and
enter its view
Set the IP address and port
number of the primary RADIUS
authentication/authorization
server
Set the IP address and port
number of the secondary
RADIUS
authentication/authorization
server
The authentication response sent from the RADIUS server to the RADIUS client carries
authorization information. Therefore, you need not (and cannot) specify a separate RADIUS
authorization server.
In an actual network environment, you can specify one server as both the primary and secondary
authentication/authorization servers, as well as specifying two RADIUS servers as the primary and
secondary authentication/authorization servers respectively.
The IP address and port number of the primary authentication server used by the default RADIUS
scheme "system" are 127.0.0.1 and 1645.

Configuring Ignorance of Assigned RADIUS Authorization Attributes

A RADIUS server can be configured to assign multiple authorization attributes, such as authorization
VLAN and idle timeout. Some users may need the attributes but some users may not. Such conflict
occurs if the RADIUS server does not support user-based attribute assignment or it performs uniformed
user management.
The RADIUS authorization attribute ignoring function can solve this issue. It is configured as per
RADIUS scheme. Users using a RADIUS scheme with this function enabled can ignore certain
unexpected attributes.
Use the command...
system-view
radius scheme
radius-scheme-name
primary authentication
ip-address [ port-number ]
secondary authentication
ip-address [ port-number ]
2-11
Remarks
—
Required
By default, a RADIUS scheme
named "system" has already
been created in the system.
Required
By default, the IP address and
UDP port number of the
primary server are 0.0.0.0 and
1812 respectively for a newly
created RADIUS scheme.
Optional
By default, the IP address and
UDP port number of the
secondary server are 0.0.0.0
and 1812 respectively for a
newly created RADIUS
scheme.