Setting To Output System Information To The Log Buffer; Setting To Output System Information To The Snmp Nms - H3C S5100-SI Operation Manual

To do...
Configure the output rules
of system information
Set the format of time stamp
in the output information

Setting to Output System Information to the Log Buffer

Follow these steps to set to output system information to the log buffer:
To do...
Enter system view
Enable the information
center
Enable information output
to the log buffer
Configure the output rules
of system information
Set the format of time stamp
in the output information

Setting to Output System Information to the SNMP NMS

Follow these steps to set to output system information to the SNMP NMS:
To do...
Enter system view
Enable the information center
Enable information output to
the SNMP NMS
Use the command...
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
info-center timestamp { log |
trap | debugging } { boot | date
| none }
Use the command...
system-view
info-center enable
info-center logbuffer
[ channel { channel-number |
channel-name } | size
buffersize ]*
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
info-center timestamp { log |
trap | debugging } { boot | date
| none }
Use the command...
system-view
info-center enable
info-center snmp channel
{ channel-number |
channel-name }
1-13
Remarks
Optional
Refer to Table 1-4 for the default
output rules of system information.
Optional
By default, the time stamp format
of the output trap information is
date.
Remarks
—
Optional
Enabled by default.
Optional
By default, the switch uses
information channel 4 to output log
information to the log buffer, which
can holds up to 512 items by
default.
Optional
Refer to Table 1-4 for the default
output rules of system information.
Optional
By default, the time stamp format
of the output log information is
date.
Remarks
—
Optional
Enabled by default.
Optional
By default, the switch outputs
trap information to SNMP
through channel 5.