Test Types Supported By Hwping; Hwping Test Parameters - H3C S5100-SI Operation Manual

Test Types Supported by HWPing

Table 1-1 Test types supported by HWPing
Supported test types
ICMP test
DHCP test
FTP test
HTTP test
DNS test
SNMP test
Jitter test
Tcppublic test
TCP test
Tcpprivate test
Udppublic test
UDP test
Udpprivate test

HWPing Test Parameters

You need to configure corresponding test parameters for each type of HWPing test. HWPing test
parameters can be configured on HWPing client only. For the configurations on the HWPing client, refer
to section HWPing Client
Table 1-2 HWPing test parameters
Test parameter
Destination address
(destination-ip)
Destination port
(destination-port)
Source interface
(source-interface)
Source address
(source-ip)
Source port
(source-port)
For these types of tests, you need to configure the HWPing
client and corresponding servers.
These types of tests need the cooperation of the HWPing
client and HWPing server.
Do not perform a TCP, UDP or jitter test on a well-known port
(ports with a number ranging from 1 to 1023) or on a port with
a port number greater than 50000. Otherwise, your HWPing
test may fail or the service corresponding to the well-known
port may become unavailable.
Configuration.
For a TCP/UDP/jitter test, you must specify a destination IP address, and
the destination address must be the IP address of a TCP/UDP/UDP
listening service configured on the HWPing server.
For a tcpprivate/udpprivate/jitter test, you must specify a destination port
number, and the destination port number must be the port number of a
TCP or UDP listening service configured on the HWPing server.
For a DHCP test, you must specify a source interface, which will be
used by the HWPing client to send DHCP requests. If no source
interface is specified for the DHCP test, the test will not succeed.
After a source interface is specified, the HWPing client uses this
source interface to send DHCP requests during the DHCP test.
The IP address of the specified source interface will be used as the
source IP address of DHCP requests.
For HWPing tests other than DHCP tests, you can specify a source IP
address for test packets, which will be used by the server as the
destination address of response packets.
For HWPing tests other than ICMP, DHCP and DNS, you can specify a
source port number for test packets, which will be used by the server as
the destination port number of response packets.
1-2
Description
Description