Autofeed-Xt - Compuprint Z03 User Manual

AutoFeed-XT

This parameter is valid in Epson-FX emulation mode only and instructs the printer
whether the host will determine if an automatic line feed is performed after a
carriage return.
You can set this value to:
Disabled
(Default)
Enabled
To change or check the AutoFeed-XT setting, follow these steps:
10. Press START or RETURN to exit the Menu. See "Exiting the configuration
94
User's Guide
The function is determined by the setting of Printer Compatibility 3 –
Automatic Line Feed on Carriage Return.
The host determines whether an automatic line feed is performed after a
carriage return.
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Parallel Interface
5. Press ENTER.
6. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Parallel Interface
AutoFeed-XT
7. Press ENTER to display the current value.
8. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
AutoFeed XT is displayed.
9. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
menu" on page 39.