Clean Carriage Underside - Oce Arizona 200 GT User Manual

Clean Carriage Underside

Introduction
To maintain optimal print quality, it is important to periodically clean the underside
of the carriage to remove any excess ink. If the buildup of ink is excessive, it can be
transferred to media and thus reduce print quality.
When to do
As part of the daily maintenance at the start of the day, or as needed, clean any ink
that has accumulated on the underside of the carriage.
Note: The accumulation of ink on the carriage underside is caused, at least in part,
by static particles from the media. Dust particles and other debris from the media
surface tend to attract ink mist when they have a static charge. To remove particles
and to reduce the static charge buildup on the media, use a tack cloth and lightly rub
the media surface before you print How to Handle Media for more information). You
may also need to install a humidifier if humidity is below the required minimum
defined in the Arizona 200/250 GT Site Preparation Guide (30% to 70%,
Non-condensing is the suggested range for operating the printer).
Before you begin
Make sure the carriage is in the parked position. The carriage and gantry
automatically return to this position after an image is printed.
It is not necessary to turn off the UV lamps as they are shuttered. However, they will
be hot if they are on, so avoid touching them.
Required tool
Cloth-Poly Wipe 10cm x 10cm
Note: Safety glasses and nitrile gloves must be worn when you handle ink.
Caution: The underside of the UV lamps may be hot, avoid touching them.
Clean Carriage Underside
153