Configure Onyx Software For White Ink - Oce Arizona 6160 XTS User Manual

Configure ONYX Software for White Ink

Configure ONYX Software for White Ink
Introduction
This section describes how to configure ONYX software (either THRIVE or ProductionHouse) to
recognize white ink workflow elements and thus allow you to apply the approach that is best for
your print job application. In order for the ONYX software to successfully address white ink
workflow data, there are options in the software that must be configured. It also explains how
you need to use specific ONYX media profiles to prepare white ink print jobs.
NOTE
Step 1 and 2 below are required for ProductionHouse only. Step 3 is needed for both
ProductionHouse and THRIVE.
Procedure
1.
Within Rip-Queue, access the Configure Rip Options Palette.
[21] Set up ONYX RIP
2. Once here, ensure that Overprint is turned on (checked).
3. In your Quick Set, or in Preflight/Job Properties/Postscript turn off two-stage processing (make
sure the box is not checked).
96 Chapter 7 ‐ How to Manage a White Ink Workflow
Océ Arizona 6100 Series