Viewing And Adding Templates - Dell PowerConnect W-Airwave User Manual


%ap_include_1% through %ap_include_10%

%channel%

%hostname%

%ip_address%

%ofdmpower%
The variable settings correspond to device-specific values on the APs/Devices > Manage configuration page for
the specific AP that is getting configured.
NOTE: Changes made on the other Group pages (Radio, Security, VLANs, SSIDs, and so forth) are not applied to any APs that are
configured by templates.

Viewing and Adding Templates

Perform these steps to display, add, or edit templates.
1. Go to the Groups > List page, and select a group for which to add or edit templates. This can be a new group,
created with the Add button, or you can edit an existing group by selecting the corresponding pencil icon. The
Groups > Basic page for that group appears. Additional information about adding and editing groups is
described in
2. From the AirWave navigation pane, select Templates. The Templates page appears.
Groups > Templates configuration page, and
Figure 112 Groups > Templates Page Illustration for a Sample Device Group
Table 89 Groups > Templates Fields and Default Values
Setting
Notes
Name
Device Type
Status
Fetch Date
152 | Creating and Using Templates
"Configuring and Using Device Groups in AirWave" on
Description
When applicable, this section lists devices that are active on the network with no template available for the
respective firmware. Select the link from such a note to launch the Add Template configuration page for that
device.
Displays the template name.
Displays the template that applies to APs or devices of the specified type. If vendor (Any Model) is selected, the
template applies to all models from that vendor that do not have a version specific template defined. If there are
two templates that might apply to a device, the template with the most restrictions takes precedence.
Displays the status of the template.
Sets the date that the template was originally fetched from a device.
page 69.
Table 89 describes the columns.
Dell PowerConnect W-AirWave 7.4 | User Guide
Figure 112 illustrates the