Configuring Cisco Catalyst Switch Templates; Configuring Symbol Controller / Hp Wesm Templates - Dell PowerConnect W-Airwave User Manual

no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
no ip address
no ip route-cache
rts threshold 2312
speed basic-6.0 basic-9.0 basic-12.0 basic-18.0 basic-24.0 36.0 48.0 54.0
ssid decibel-ios-a
authentication open
guest-mode
station-role root

Configuring Cisco Catalyst Switch Templates

Cisco Catalyst Switch templates are configured much like Cisco IOS templates with the addition of the
interfaces
Interface pages, as shown in
information as described in this section or by fetching a template from that device, as described in
General Templates" on
NOTE: Just one template is used for any type of Cisco IOS device, and another is used for any type of Catalyst Switch regardless of
individual model.

Configuring Symbol Controller / HP WESM Templates

This section describes the configuration of templates for Symbol controllers and HP WESM devices.
Symbol controllers (RFS x000, 5100 and 2000) can be configured in AMP using templates. AMP supports Symbol
thin AP firmware upgrades from the controller's manage page.
A sample running-configuration file template is provided in this topic for reference. A template can be fetched
from a model device using the Cisco IOS device procedure described in
page 156. Cisco IOS template directives such as
templates.
Certain parameters such as
specific values can be read from the individual manage pages and inserted into the template. They are listed in
Available Variable boxes on the right-hand side of the template fields.
Certain settings have integrated variables, including
preamble has been template-integrated as well. An option on the Group > Templates page reboots the device
after pushing a configuration to it.
A sample Symbol controller partial template is included below for reference.
!
! configuration of RFS4000 version 4.2.1.0-005R
!
version 1.4
!
!
aaa authentication login default local none
service prompt crash-info
!
network-element-id RFS4000
!
username admin password 1 5baa61e4c9b93f3f0682250b6cf8331b7ee68fd8
158 | Creating and Using Templates
%ENDIF%
and (for stacked switches) variables. Interfaces can be configured on the Device
switch_command
"Configuring Device Interfaces for Switches" on
page 151.
hostname
ignore_and_do_not_push
and are turned into variables with the
location
ap-license
page 138. You can import interface
"Configuring Cisco IOS Templates" on
can also be applied to Symbol
tags so that device-
%
and
adoption-preference-id
Dell PowerConnect W-AirWave | Version 7.3
"Configuring
. The radio