Displaying Port Mirroring Status; Deleting A Mirroring Session - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Diagnosing Switch Problems
To enable a port mirroring session, enter the
session ID number and the keyword enable. The following command enables port mirroring session 6
(turning port mirroring on):
-> port mirroring 6 enable
Note. Port mirroring session parameters cannot be modified when a mirroring session is enabled. Before
you can modify parameters, the mirroring session must be disabled.
To disable a port mirroring session, enter the port mirroring command, followed by the port mirroring
session ID number and the keyword disable. The following command disables port mirroring session 6
(turning port mirroring off):
-> port mirroring 6 disable

Displaying Port Mirroring Status

To display port mirroring status, use the
mirroring sessions, enter:
-> show port mirroring status 6
Session Mirror
Destination
----------+----------+--------------+----------+----------+---------
1. 2/1
----------+----------+--------------+----------+----------+---------
Mirror
Source
----------+----------+--------------+----------+----------+---------
1. 1/1
1. 1/2
1. 1/3
1. 1/4
1. 1/5

Deleting A Mirroring Session

The no form of the port mirroring
configuration between a mirrored port and a mirroring port.
To delete a mirroring session, enter the no port mirroring command, followed by the port mirroring
session ID number. For example:
-> no port mirroring 6
In this example, port mirroring session 6 is deleted.
Note. The port mirroring session identifier must always be specified.
OmniSwitch AOS Release 6 Network Configuration Guide
port mirroring
show port mirroring status
Mirror Unblocked
Direction Vlan
- NONE
bidirectional -
bidirectional -
bidirectional -
bidirectional -
bidirectional -
command can be used to delete a previously created mirroring session
September 2009
command, followed by the port mirroring
command. To display all port
Config Oper
Status Status
Enable On
Enable On
Enable On
Enable On
Enable On
Enable On
Port Mirroring
page 45-21