Table of Contents
Advertisement
See the Alcatel AOS-W User's Guide for information on using the features
available through this port.
7
Utilization LEDs
The supervisor card has a bank of five utilization LEDs. While booting, these
LEDs light in sequential fashion.
During operation, these LEDs light to indicate the level of activity in a
functioning module. Each LED from left to right represents an increment of
20% in the activity of the supervisor card. When all five LEDs are lit, the SCM
is functioning at 100% capacity.
The right-most of the lit LEDs will blink to verify the supervisor card is
operating properly. No LEDs will be lit if the module is in standby mode or not
functioning.
8
Reset button
Only push the reset button when directed to do so by Alcatel technical
support.
Port & Cable Specifications
Serial Port
The serial port is located on the front panel of the supervisor card. The port's
RJ-45 female connector accepts an RS-232 serial cable with a male connector.
Pin-outs are shown in
Console Port
F
IGURE
Figure
6-2:
Serial
RJ-45 Female
Pin-Out
Direction
Input
Output
6-2 Serial Port
1
2
3
TxD
4
TGND
5
RGND
6
RxD
7
8
Chapter 6
The Supervisor Card
39
Advertisement
Table of Contents
