Installing The Side Panel Blanks On The It Racks - HP Adaptive Rack Cooling System System Installation Manual

6. On the rear of the HPE Adaptive Rack Cooling System, join the two reference ports with a section of
the tubing and a Y-connector.
7. Connect the HPE Adaptive Rack Cooling System reference ports to the pressure pickup tube.
8. Install side panels at the end of each row of racks. For more information on installing side panel
blanks, see Installing the side panel blanks on the IT racks.

Installing the side panel blanks on the IT racks

To close off the racks at the end of a row, install side panel blanks on the IT racks. Installing the blanks
isolates the racks from the room environment.
NOTE: The following illustrations show panel installation on the left row end. Installation on the right row
end is the same but in mirror image.
Configuration 25