Connecting To The Target System; To Power Up Or Power Down - HP E2465A PowerPC 604 PGA User Manual

Connecting to the Target System
Connecting to the target system consists of the following steps:
• Turn
off the logic analyzer and the target system.
• Connect the preprocessor interface to the target system.
The remainder of this section describes these general steps
in
more
detail.
To power up or power down
To protect your equipment, remove the power from both the logic analyzer
and the target system before you make or break connections. The logic
analyzer provides power to the circuits on the preprocessor interface, and
should always be powered up before the target system. When powering
down, power down the target system first and then power down the logic
analyzer.
E2465A PowerPC 604 PGA Preprocessor
1-5