Configuration Using The System Set Config Wizard; System Configuration Using System Set Config Command; Configure Network; Configure Time - HP StoreOnce 2700 Installation And Configuration Manual

4 Configuration using the system set config wizard

The StoreOnce CLI command set provides two configuration wizards:
The system set config command sequence packages a number of commands, some of
which you may skip, if required. This wizard is recommend if you wish to configure time and
license settings at the same time as network settings and run a health check. The network
configuration element of this wizard uses the net set wizard command.
The net set wizard command sequence configures network settings and is described in
detail in
Abstract
It is recommended that you read
before running either wizard for the first time.

System configuration using system set config command

The recommended configuration option at installation is to use the StoreOnce CLI wizard, system
set config. This command sequence packages a number of commands, some of which you
may skip, if required.
Before running the wizard collect and verify the required network information, see
net set wizard (page
Four actions are available at each step, as shown in the example below; execute, skip, back
and quit. (The network must be configured.)
# system set config
The following configuration steps will be performed.
>Configure Network

Configure Time

Configure Licenses
Verify Hardware health
Finish Configuration and reboot
Finish Configuration
Actions:
execute) Perform current step (Default)
skip) Skip to the next step
back) Go back to a previous step
quit) Exit the configuration immediately
Each of the configuration steps listed above in the wizard is now described in more detail.

Configure network

This step runs through the network configuration and is equivalent to running the net set wizard
command. This step must be completed.
The wizard guides you through the network configuration on the StoreOnce Backup system. It
configures all network settings for all subnets.
NOTE: See
wizard sequence.
Configure Time
This step allows you to set the time explicitly or set it using NTP server. If you select NTP server you
will be asked to specify up to two NTP server names (or IP addresses) and select the timezone.
You may skip this step and configure time later. See
28 Configuration using the system set config wizard
Network configuration, how to use StoreOnce CLI commands (page
Network configuration, understanding the concepts (page 30)
39).
Network configuration using net set wizard (page 41) for an example net set
Setting up time and date (page
38).
Before running
59).