Restore Default Settings; Raw Nvram Data; Advanced Adapter Settings - Qlogic SANblade 2300 Series User Manual


Some new system BIOSs support selectable boot, which supersedes the Fast!UTIL
selectable boot setting. To boot from an FC hard disk attached to the
QLA2340/2340L HBA, select the QLA2340/2340L HBA FC hard disk on the system
BIOS.
NOTE: This option applies only to hard disks; it does not apply to tape drives and
other nondisk devices.
2.3.2.3

Restore Default Settings

The Restore Defaults option from the Configuration Settings menu restores the
QLA2340/2340L HBA default settings.
2.3.2.4

Raw NVRAM Data

This option displays the adapter's NVRAM contents in hexadecimal format. This is
a QLogic troubleshooting tool; you cannot modify the data.
2.3.2.5

Advanced Adapter Settings

From the Configuration Settings menu in Fast!UTIL, select Advanced Adapter
Settings. The default settings for the QLA2340/2340L HBA are listed in
and described in the following paragraphs.
Setting
Execution Throttle
Fast Command Posting
>4GByte Addressing
Luns per Target
Enable LIP Reset
Enable LIP Full Login
Enable Target Reset
Login Retry Count
Port Down Retry Count
Drivers Load RISC Code
Enable Database Updates
FC2354601-00 A
Table 2-2. Advanced Adapter Settings
1–256
Enabled, Disabled
Enabled, Disabled
0, 8, 16, 32, 64, 128, 256
Yes, No
Yes, No
Yes, No
0–255
0–255
Enabled, Disabled
Yes, No
Options
2 – QLA2340/2340L
Fast!UTIL
table 2-2
Default
16
Disabled
Disabled
8
No
Yes
Yes
8
30
Enabled
No
2-7