Setting Up Mba In A Client Environment; Enabling The Mba Driver; Configuring The Mba Driver - Qlogic FastLinQ 3400 Series User Manual

3–Multi-boot Agent (MBA) Driver Software

Setting Up MBA in a Client Environment

Setting Up MBA in a Client Environment
Setting up MBA in a client environment involves the following steps:
1.

Enabling the MBA driver.

2.

Configuring the MBA driver.

3. Setting up the BIOS for the boot order.
Enabling the MBA Driver
To enable or disable the MBA driver:
1. Insert an MS-DOS 6.22 or a Real Mode Kernel bootable disk containing the
uxdiag.exe file (for 10/100/1000Mbps network adapters) or uediag.exe
(for 10Gbps network adapters) in the removable disk drive and power up
your system.
NOTE
The uxdiag.exe (or uediag.exe) file is on the installation CD or in the
DOS Utilities package available from driverdownloads.qlogic.com/.
2. Type:
uxdiag -mba [ 0-disable | 1-enable ] -c devnum
(or uediag -mba [ 0-disable | 1-enable ] -c devnum)
where
devnum is the specific device(s) number (0,1,2, ...) to be programmed.
Configuring the MBA Driver
This section describes the configuration of the MBA driver on add-in NIC models
of the QLogic network adapter using the Comprehensive Configuration
Management (CCM) utility. To configure the MBA driver on LOM models of the
QLogic network adapter, check your system documentation. Both the MBA driver
and the CCM utility reside on the adapter Flash memory.
13 83840-546-00 E