Garp Timers - Dell PowerConnect 5316M User Manual

Interface — Determines if enabled on a port or on a LAG.
GARP Join Timer (10 - 2147483640) — Time, in milliseconds, that PDUs are transmitted. The
default value is 200 msec.
GARP Leave Timer (10 - 2147483640) — Time lapse, in milliseconds, that the switch module
waits before leaving its GARP state. Leave time is activated by a Leave All Time message
sent/received, and cancelled by the Join message received. Leave time must be greater than or
equal to three times the join time. The default value is 600 msec.
GARP Leave All Timer (10 - 2147483640) — Time lapse, in milliseconds, that all switch modules
wait before leaving the GARP state. The leave all time must be greater than the leave time
default value is 10000 msec.
Defining GARP Timers
1
Open the GARP Timers page.
2
Complete the fields.
3
Click Apply Changes.
The GARP parameters are saved to the switch module.
Copying Parameters in the GARP Timers Table
1
Open the GARP Timers page.
2
Click Show All.
The GARP Timers Table opens.
3
Select the interface type in the Copy Parameters from field.
4
Select an interface in either the Port or LAG drop-down menu.
The definitions for this interface is copied to the selected interfaces. See step 6.
5
Select the Copy to check box to define the interfaces to which the GARP timer definitions
are copied, or click Select All to copy the definitions to all ports or LAGs.
6
Click Apply Changes.
The parameters are copied to the selected ports or LAGs in the GARP Timers Table, and the
switch module is updated.
Defining GARP Timers Using CLI Commands
This table summarizes the equivalent CLI commands for defining GARP timers as displayed in the
GARP Timers page.
Configuring Switch Module Information
The
.
205