Viewing Dynamic Addresses; Static Address Cli Commands - Dell PowerConnect 5316M User Manual

Configuring Static Address Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring static address
parameters as displayed in the Static MAC Address page.
Table 7-52. Static Address CLI Commands
CLI Command
bridge address mac-address [permanent
| delete-on-reset | delete-on-timeout |
secure] {ethernet interface | port-
channel port-channel-number}
show bridge address-table [vlan vlan]
[ethernet interface | port-channel port-
channel-number]
The following is an example of the CLI commands:.
console(config-if)#bridge address 00:60:70:4C:73:FF permanenet
ethernet g8
Console# show bridge address-table
Aging time is 300 sec
vlan mac address
---- ------------
1 00:60:70:4C:73:FF
1 00:60:70:8C:73:FF
200 00:10:0D:48:37:FF

Viewing Dynamic Addresses

The Dynamic Addresses Table contains fields for querying information in the dynamic address
table, including the interface type, MAC addresses, and VLANs. Packets forwarded to an address
stored in the address table are forwarded directly to those ports. The Dynamic Addresses Table also
contains information about the aging time before a dynamic MAC address is erased, and includes
parameters for querying and viewing the Dynamic Address list.
The Current Address Table contains specific dynamic MAC Address information, including the
VLAN ID, ports associated with the MAC address, and the MAC address.
To open the Dynamic Addresses Table, click Switch→ Address Table→ Dynamic Addresses Table
in the tree view.
Description
Adds a static MAC-layer station source
address to the bridge table.
Displays entries in the bridge-forwarding
database.
port
----
g8
g8
g9
type
--------
dynamic
dynamic
static
Configuring Switch Module Information
201