Multicast Service Member Cli Commands - Dell PowerConnect 5316M User Manual

2
Define the VLAN ID and the Bridge Multicast Address fields.
3
Toggle the LAG to S to join the LAG to the selected Multicast group.
4
Toggle the LAG to F to forbid adding specific Multicast addresses to a specific LAG.
5
Click Apply Changes.
The LAG is assigned to the Multicast group, and the switch module is updated.
Managing Multicast Service Members Using CLI Commands
The following table summarizes the equivalent CLI commands for managing Multicast service
members as displayed in the Bridge Multicast Group page.
Table 7-71. Multicast Service Member CLI Commands
CLI Command
bridge multicast address {mac-
multicast-address | ip-multicast-
address}
bridge multicast forbidden address
{mac-multicast-address | ip-multicast-
address}[add | remove] {ethernet
interface-list | port-channel port-
channel-number-list}
show bridge multicast address-table
[vlan vlan- id ] [address mac-
multicast-address | ip-multicast-
address] [format ip | mac]
The following is an example of the CLI commands:
Console(config-if)# bridge multicast address 0100.5e02.0203
add ethernet g11,g12
console(config-if)# end
console # show bridge multicast address-table
Vlan MAC Address
---- -----------
1 0100.5e02.0203
19 0100.5e02.0208
19 0100.5e02.0208
Description
Registers MAC-layer Multicast
addresses to the bridge table, and
adds static ports to the group.
Forbids adding a specific Multicast
address to specific ports. Use the no
form of this command to return to
default
Displays Multicast MAC address
table information.
Type
-----
static
static
dynamic
Ports
----------
g11, g12
g11-16
g11-12
Configuring Switch Module Information
247