Dell PowerConnect 5316M User Manual page 50

For further details on configuring and using the DRAC/MC see Dell Remote Access Controller
/ Modular Chassis User's Guide.
Once the Ethernet Switch Module is connected to the console, wait until the Ethernet
Switch Module is fully booted. Observe the booting information being outputted to the
terminal window and wait for the Ethernet Switch Module CLI command prompt "console>"
to appear. Press <Enter> several times in order to ensure that the terminal connection is
successfully established and the Ethernet Switch Module can be configured through the CLI
command interface.
6
Make sure that the system LED on the Ethernet Switch Module is illuminated green and is
not flashing, which indicates that the Ethernet Switch Module is operating properly.
An output similar to the following will be displayed on the terminal window:
Remote Access Controller / Modular Chassis (DRAC/MC)
Copyright (C) 2000-2004 Dell Inc. All Rights Reserved.
Login: root
Password: ******
DRAC/MC: racadm chassisaction -m chassis powerup
OK
DRAC/MC: racadm chassisaction -m switch-1 powercycle
OK
DRAC/MC: connect switch-1
Connected to switch-1 ...
------ Performing the Power-On Self Test (POST) ------
UART Channel Loopback Test........................PASS
Testing the System SDRAM..........................PASS
Boot1 Checksum Test...............................PASS
Boot2 Checksum Test...............................PASS
Flash Image Validation Test.......................PASS
FRU Validation Test...............................PASS
34
Installing the Ethernet Switch Module