4
Click Apply Changes.
The selected IP address is deleted, and the switch module is updated.
Defining IP Interfaces Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
IP Interface Parameters page.
Table 6-24. IP Interface Parameters CLI Commands
CLI Command
ip address ip-address {mask |
prefix-length}
no ip address [ip-address]
show ip interface [ethernet
interface-number | vlan vlan-
id | port-channel number]
The following is an example of the CLI commands:
console(config)# interface vlan 1
console(config-if)# ip address 92.168.1.123 255.255.255.0
console(config-if)# no ip address 92.168.1.123
console(config-if)# end
console# show ip interface vlan 1
Output
Gateway IP AddressActivity status
---------------------------------------
192.168.1.1Active
IP addressInterfaceType
-------------------------------------------
192.168.1.123/24VLAN 1Static
106
Configuring System Information
Description
Sets an IP address.
Removes an IP address
Displays the usability status of interfaces
configured for IP .