Lacp Parameters Cli Commands - Dell PowerConnect 5316M User Manual

Defining Link Aggregation Port Parameters
1
Open the LACP Parameters page.
2
Complete the fields in the Port Parameters area.
3
Click Apply Changes.
The parameters are defined, and the switch module is updated.
Displaying the LACP Parameters Table
1
Open the LACP Parameters page.
2
Click Show All.
The LACP Parameters Table opens.
Configuring LACP Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring LACP parameters
as displayed in the LACP Parameters page.
Table 7-67. LACP Parameters CLI Commands
CLI Command
lacp system-priority value
lacp port-priority value
lacp timeout {long | short}
show lacp ethernet interface
[parameters | statistics |
protocol-state]
Description
Configures the system priority.
Configures the priority value for physical
ports.
Assigns an administrative LACP timeout.
Displays LACP information for ethernet
ports.
Configuring Switch Module Information
239