8.3
Altering numerical values, parameter values and selection of alternatives
8.3.1
Alter numerical values
18
Call up the technician mode
–
Turn on the main switch.
The control unit is initialized.
The sewing mode menu appears on the display.
–
Press the "F" key.
–
Enter Code 1 (see Chapter 8.5.4).
–
Press the "OK" key.
–
The display changes over to the technician mode.
–
Select the desired line with the "ñ" and "ò" keys.
–
Press the "OK" key.
The chosen numerical value is marked by a blinking cursor.
–
Change between the points with the "ï" or "ð" keys.
Increase or reduce the value of the selected point by one with the
"ñ" and "ò" keys.
–
Press the "OK" key.
The currently set value is applied.
or
–
Press the "ESC" key.
The original value is maintained.
Note
All values can only be altered within the range of minimum and
maximum values.