Duerkopp Adler 511 Operating Instructions Manual page 64

60
Initialization (Init)
This is the selection of the sub-menu for the initialization of the event
memory and the permanent data.
Event memory
Progr./Sequ.
Mach./User p.
Free Contours
Maschine cpl.
Event memory
Using this menu item, the event memory can be reset.
Seam pattern programs (variants) and sequences
Using this menu item, seam pattern programs and sequences can be
deleted.
Machine parameters
This menu item is used to reset factory default settings for the
following: the machine parameters, soft start driving speeds, timings,
user configuration, hook thread counter data options and the
availability of a monitoring switch for clamping foot.
Free seam contours
Using this menu item, all free seam contours can be reset (deleted).
Note
The reset may cause seam pattern programs and sequences to be
deleted. The numbers of subsequent programs and sequences may
also be altered.
Machine complete
Using this menu item, all permanent data can be reset. After resetting,
the machine will automatically be restarted.
Note
After the restart of the machine, a new selection of the clamp numbers
and the equipment must be carried out (refer to Installation
Instructions, chapter 9).