9.3
Changing parameter values
9.3.1
Numerical values
9.3.2
Selecting a parameter
Numerical values can be changed in the following way:
Use the ñ and ò cursor keys to select the line containing the value
–
you wish to change.
–
Press the enter key.
The cursor flashes under one digit of the numerical value.
Use the ï and ð cursor keys to move from one digit to another.
–
Use the ñ and ò cursor keys to increase or reduce the value of the
selected digit.
Where parameters are limited to certain values (e.g. eye shape),
pressing the ñ and ò cursor keys displays another possible
parameter value.
–
Press OK.
The set value is accepted.
–
If the set value is not to be accepted, press "ESC".
The original value is restored.
Some parameters allow selection among a number of possibilities.
These parameters can be changed in the following way:
Use the ñ and ò cursor keys to select the line containing the
–
parameter or value to be changed.
–
Press OK.
Use the ñ and ò cursor keys to switch from one possibility to another.
–
The selected symbol appears in the display.
Exception:
to switch cut mode use the ï and ð cursor keys.
–
Press the enter key.
The set parameter or value is accepted.
–
If the set parameter or value is not to be accepted, press "ESC".
The original parameter or value is restored.
1
23