Duerkopp Adler 511 Operating Instructions Manual page 26

22
Thread tension in range 1 (refer to table 1)
Input: 0 – 100
The thread tension magnet adjusts the thread tension
according to the current value so that it can then be
checked.
The thread tension values for all further ranges in the seam pattern are
set as the difference to the previous value.
For the standard seam patterns (1 – 50), the thread tension cannot be
individually set for the different ranges. If this is required, then a seam
pattern program must be created.
Sub-menu for seam pattern size and offset
Select this sub-menu to set the seam pattern length
and width.
Display:
When switching to this menu, the clamping foot will be lowered. If the
value for the X- and Y-Offset is changed, the stepping motors will move
the material accordingly. When exiting the sub-menu, the clamping foot
will then be raised again.
Caution – Risk of Injury !
Do not reach into the working area of the machine while you are in this
sub-menu and performing changes on the seam pattern offset.
0 = lowest thread tension
100 = highest thread tension
current length/width
Width
Setting the seam pattern width
Input: 0.1 – 40 [mm]
Length
Setting the seam pattern length
Input: 0.1 – 20 [mm]
X Offset
Setting the seam pattern offset in the
X-direction.
Input: -20.0 – +20.0
Y Offset
Setting the seam pattern offset in the
Y-direction.
Input: -10.0 – +10.0