Seam Pattern; Power Saving Mode - Duerkopp Adler 511 Operating Instructions Manual

8.4

Seam pattern

8.5

Power saving mode

20
Three different seam pattern types are available for the automatic
bartacker 511:
·
Specified standard seam patterns (Type 1) (see chapter 11):
The sewing parameters length, width and sewing speed can be
altered in the sewing mode; the laser marking lamps can be
switched on and off. The alterations are saved.
However, after selection of another seam pattern, the alterations
will be lost.
For these seam patterns the seam pattern numbers 1 to 50 are
available and cannot be deleted or overwritten.
·
Programmable seam patterns (Type 2)
Specified standard seam patterns can be altered in the
programming level (length, width, sewing speed, laser light 1 to 8)
and saved under a new program number.
For these seam patterns, the seam pattern numbers 51 to 90 are
available and can be deleted or overwritten.
·
Free seam contours (Type 3):
For these seam contours, the seam patterns numbers 91 to 99 are
available. The creation of free seam contours is described in
chapter 8.5.4.4.
The sewing parameters length, width and sewing speed can be
altered in the sewing mode; the laser marking lamps can be
switched on and off. The alterations are saved.
However, after selection of another seam pattern, the alterations
will be lost.
Power saving mode is activated after an adjustable interval (1 – 60
min) by using t5 in the Machine Configuration/Times menu. Power
saving mode can be deactivated by setting t5 to 0.
The clamping foot descends when it is activated in order to save
power. This also reduces the generation of heat.
The defined time elapses when there is no user input is carried out on
the control panel, pedal or hand switch.
Before the power saving mode activates, a message indicating that the
clamping foot will descend flashes twice as an alert.
After that, the message stays on the screen.
As soon as a user operates the control panel, pedal or hand switch, the
normal mode of operations is resumed. The clamping foot is then
raised and the message is no longer displayed.
The machine is now ready for use.