8.3 Alter numerical values, parameter values, selection of alternatives
8.3.1
Alter numerical values
Call up the technician mode
–
Switch on main switch.
The control is initialized.
The sewing mode menu appears on the display.
–
Press key " F ".
–
Enter Code 1 (see Chapter 8.5.4).
–
Press key "OK" .
The display changes over to the technician mode.
–
Select the desired line with the keys "ñ" or "ò".
–
Press key "OK".
The chosen numerical value is marked by a blinking cursor.
–
Change between the points with the keys "ï" or "ð".
Increase or reduce the value of the selected point by one with the
keys "ñ" or "ò".
–
Press key "OK".
The currently set value is taken over.
or
–
Press key "ESC".
The original value is maintained.
Note
All values can only be altered within the minimum and maximum
values.
1
21