Application Messages - Duerkopp Adler 511 Operating Instructions Manual

8.8.2

Application messages

Icon Description
Capacity counter is zero
Handwheel turned
manually
The contour overlaps the
clamping-foot
inner frame in the X or Y
direction.
The contour overlaps the
clamping-foot inner frame
in the –X or +X and +Y
direction.
The contour overlaps the
clamping-foot inner frame
in the –X or +X and +Y
direction.
The contour overlaps the
clamping-foot inner frame
in the +X and –Y or +Y
direction.
The contour overlaps the
clamping-foot inner frame
in the X and –Y or +Y
direction.
The contour overlaps the
clamping-foot inner frame
in the –Y or +Y direction.
Time expired without
operator input
Category
Note • The clamping foot can be lowered only
after pressing the "OK" key.
• The message disappears after the key
is pressed.
• After pressing the key, the capacity
counter is reset to its starting value.
Caution After aborting the sewing process:
• No further sewing is possible
• Abort the sewing process by pressing
back on the pedal.
• Confirm with hand switch 1 (clamps) or
with the "ESC" key on the control panel.
Caution • No sewing start is possible
• Select another clamping foot
• Select another seam pattern
• Decrease the X offset in the
appropriate direction
Caution • No sewing start is possible
• Select another clamping foot
• Select another seam pattern
• Decrease the X offset in the
appropriate direction
• Decrease the seam pattern in the
Y direction
Caution • No sewing start is possible
• Select another clamping foot
• Select another seam pattern
• Decrease the X offset
• Decrease the Y offset in the
appropriate direction
Caution • No sewing start is possible
• Select another clamping foot
• Select another seam pattern
• Decrease the X offset
• Decrease the Y offset in the
appropriate direction
Caution • No sewing start is possible
• Select another clamping foot
• Select another seam pattern
• Decrease the seam pattern in the
X direction
• Decrease the Y offset in the
appropriate direction
Caution • No sewing start is possible
• Select another clamping foot
• Select another seam pattern
• Decrease the Y offset in the
appropriate direction
• The clamping foot is lowered
Action
1
81