Programming A Sequence - Duerkopp Adler 511 Operating Instructions Manual

8.6.3.2 Programming a sequence

In this menu item, individual seam patterns are combined to form
retrievable seam pattern sequences.
A total of 25 independent seam pattern sequences are available. Every
seam pattern sequence can be combined out of 20 seam patterns in
any order.
The seam pattern sequence operations can also be turned on in this
menu.
–
Turn on the main switch.
The control unit is initialized.
The main menu appears.
–
Press function key "S" in the main menu.
The display changes over to the menu of the sequence
programming mode.
–
Select desired menu item with the "ñ" and "ò" keys.
The menu line is displayed white on black.
–
Press the "ESC " or "ï"key.
Back to the main menu.
Sequence number/ seam pattern sequence operation
Selection of the sequence to be created or to be altered.
When preparing a new program, an asterisk (*) is indicated before the
number.
Input: 0 – 25
–
Select the desired sequence number with the "ñ" and "ò" keys.
If the seam pattern sequence operation should be switched off,
select the sequence number 0.
The menu line is displayed white on black.
–
Press the "OK" key.
The program is activated.
Seam pattern number (1 – 20)
With this menu item, you can select the seam pattern number to be
taken up in the current sequence.
Input: 1 51 (52 – 99 if available)
1
33