Duerkopp Adler 511 Operating Instructions Manual page 78

74
Contents
With this menu item, the content of a memory dongle connected to the
control unit can be displayed.
Before the following four data types are loaded, a confirmation window
is displayed.
–
Press the "ï" key (no) in order to abort the process.
Press the "ð" key (yes) in order to continue with the process.
The time needed for the upload depends on the number of seam
pattern programs and free seam contours.
Free seam contours
The loading of all free seam contours can be started with this menu
item. A confirmation window will be shown for confirming your
selection.
All free seam contours on the machine will be deleted when uploading
from the dongle!
Seam pattern programs and sequences
The loading of all seam pattern programs and sequences can be
started with this menu item.
All seam pattern programs and sequences on the machine are
overwritten when loading from the memory dongle.
If seam pattern programs or sequences refer to unavailable free seam
contours, then they are deleted after they are loaded! In such a case,
the free seam contour should be loaded first or use the "Machine
complete" menu item!
Machine parameters
The loading of the machine parameters can be started with this menu
item.
The following data is loaded from the memory dongle:
cutting speed, reference speed, loading positions, maximum sewing
speed, stop position, current seam pattern number, current standard
seam pattern data (in the event that the equipment corresponds).
All machine parameters on the machine are overwritten when
uploading from the memory dongle.
Machine complete
The loading of all the data ranges listed above can be started with this
menu item.
All data on the machine is overwritten when uploading from the
memory dongle.