Speedometer Drive Gear; Fitting The Differential In The Casing; Electronic Version - Renault Clio Workshop Repair Manual

- Output bearing shaft (34).
N N N N E E E E V V V V E E E E R R R R U U U U S S S S E E E E T T T T H H H H E E E E C C C C O O O O N N N N V V V V E E E E R R R R T T T T E E E E R R R R C C C C A A A A S S S S I I I I N N N N G G G G A A A A S S S S A A A A S S S S U U U U P P P P - - - -
P P P P O O O O R R R R T T T T
Fit a block (C) under the stator shaft.
Offer up the needle bearing (34) and push it on,
using the press, so that it is flush with the stator
shaft face.

Speedometer drive gear (35)

The drive gear and its shaft are refitted by hand.
The shaft must be correctly positioned in relation
to the gear locating spigots, owing to the elastic-
ity of the lips of the shaft.
Using a mallet, ensure they are properly clipped
in.
AUTOMATIC TRANSMISSION
Final drive assembly (MB)
88942R
86053S

Fitting the differential in the casing.

In all assemblies where washers (40) are required
(see page 137), place them in front of the spring
washer (24) and ensure (24) is the right way
round.

Electronic version

Fit sensor wheel (37) and (39 - 38).
Place the differential in the converter and diffe-
rential casing and fit it on the press.
23-81
23
85798R
86374R3