Fitting The Output Shaft - Renault Clio Workshop Repair Manual

Fitting the output shaft (39)

In the final drive fit:
- the needle bearing (43) on the press,
- the spring ring (15).
Place pinion (9) in the final drive (shoulder at con-
verter end).
At the same time, thread onto the output shaft
(39), the step-down gear (9) and the speedometer
drive wheel (11) (with the notch towards the con-
verter). Fit the half circlip (10) (check that (11) is
properly clipped in place).
On the output shaft (39), fit:
- the washer (8),
- the bearing (7) with the groove opposite the
converter and spread spring ring (15) apart,
- the belleville washer (6) (see diagram for di-
rection of fitting),
- the circlip (5), fitting it under groove (G).
When fitting circlip (5) into its groove, use tool B.
Vi. 959:
- fit the washer (D) from the tool onto the
circlip,
- place the crescent piece (E) from the tool in
the groove (G) and tighten the three bolts (V)
until the circlip (5) enters its groove.
Ensure that (5) is in the correct position.
AUTOMATIC TRANSMISSION
Final drive assembly (MJ)
Fit the spacer (2) and the adjusting shim (1).
23-95
23
85851R4
86137R1