As from 1985, on
M M M M B B B B
automatic transmissions, the VERTO diameter 216 converter has been replaced by a
RENAULT diameter 227 converter.
Replacing the torque converter involves:
-
replacing the drive plate,
-
replacing the pump, turbine and stator shafts.
The method for removing and refitting the torque converter and pump and turbine shafts on the automatic
transmission is the same as the method described on the following page.
R R R R E E E E M M M M O O O O V V V V A A A A L L L L
Remove the retaining bracket B. Vi.465.
Pull the converter towards you and remove it.
AUTOMATIC TRANSMISSION
Converter
S S S S P P P P E E E E C C C C I I I I A A A A L L L L T T T T O O O O O O O O L L L L I I I I N N N N G G G G R R R R E E E E Q Q Q Q U U U U I I I I R R R R E E E E D D D D
B. Vi.
465
Tooling for replacing the
converter seal
85710-1R
C C C C H H H H E E E E C C C C K K K K I I I I N N N N G G G G
Check the condition of:
-
the converter centring device (1) (at crank-
shaft and converter end) diameter 16:
diameter 40 :
-
the sealing area (2),
-
the converter"white metal" bush (3),
-
the free wheel (4) for
-
the three securing points or studs,
-
the ignition sensor target (5).
23-44
M M M M J J J J , , , , M M M M L L L L
,
M M M M B B B B 1 1 1 1
,
23
M M M M B B B B - - - -