Renault Clio Workshop Repair Manual page 38

H H H H Y Y Y Y D D D D R R R R A A A A U U U U L L L L I I I I C C C C D D D D I I I I S S S S T T T T R R R R I I I I B B B B U U U U T T T T O O O O R R R R P P P P L L L L A A A A T T T T E E E E
(Modification)
Some vehicles may change abruptly from 2nd to
3rd gear and vice versa when driving particularly
slowly in town.
The distributor plate can be modified (only on ve-
hicles fitted with MB1 automatic transmission
and up until 1994 ).
Special tooling:
- 1 drill bit diameter 2.5 mm.
- 1 drill bit diameter 1.1 mm.
1) Reduce the dividing hole n 21 diameter 1.3
mm so that it becomes 1.1 mm.
Put the plate on a flat, hard and clean surface.
Using a 3 or 4 mm punch and a copper ham-
mer, restrict the diameter to 1.1 mm.
If necessary, check the 1.1 mm again.
2) Increase hole E2 n 11 diameter 1.7 mm to 2.5
mm.
A Hole n 21 diameter 1.3 mm becomes 1.1 mm.
Hole n 11 diameter 1.7 mm becomes 2.5 mm.
B
AUTOMATIC TRANSMISSION
Hydraulic distributor
DI2356
3) Perform the following:
- clean the plate,
- replace the seals.
Tighten the distributor bolts to the correct torque.
The oil pressure must be checked and adjusted if
necessary (see relevant section).
23-36
23