Renault Clio Workshop Repair Manual page 107

- the needle bearing (7) on the press, fitting di-
mension 37 mm,
- the step-down shaft (12),
- the output shaft (8),
- the speedometer seal using tool B. Vi. 905-02,
- a new speedometer drive gear with its shaft.
(Check that the speedometer drive clips cor-
rectly into its shaft).
AUTOMATIC TRANSMISSION
Final drive assembly (ML)
88209R1
88209-1R
Before coupling the step-down casing to the
converter/final drive casing, check that the loca-
ting dowel (A) is in position and coat the faces of
the casings with "
I I I I M M M M P P P P O O O O R R R R T T T T A A A A N N N N T T T T : : : : the two bolts under the stator shaft
must be coated with "
R R R R E E E E A A A A S S S S S S S S E E E E M M M M B B B B L L L L I I I I N N N N G G G G T T T T H H H H E E E E S S S S E E E E P P P P A A A A R R R R A A A A T T T T O O O O R R R R H H H H O O O O U U U U S S S S I I I I N N N N G G G G
Refit:
- circlips (3) and (11), with the notches on the
same side,
23-105
L L L L o o o o c c c c t t t t i i i i t t t t e e e e F F F F O O O O R R R R M M M M A A A A J J J J O O O O I I I I N N N N T T T T
".
L L L L o o o o c c c c t t t t i i i i t t t t e e e e F F F F O O O O R R R R M M M M A A A A J J J J O O O O I I I I N N N N T T T T
23
88208R2
".
88207-1R