Chart 22: Reversing Lights Do Not Work But The Starter Motor Works - Renault Clio Workshop Repair Manual

If the warning light is operational and it remains extinguished
when there is a fault, check the condition of the reversing lights
bulbs and check the earth on the rear lights units.
After the operation, does the fault persist?
Check the reversing lights fuse.
Disconnect the 6 track computer connector
and check the condition of the connections.
Ignition on, is there
+ Battery feed on track A on the wiring side ?
Correct no
yes -
Recheck
-
your
diagnosis
Cut the multifunction switch cable as if a replacement were being made.
With the switch still in position on the automatic transmission, repeat the previous tests at the switch side
Replace the multifunction switch.
* And vehicles where load information and TDC information is given by the injection computer.
AUTOMATIC TRANSMISSION
Fault finding aid
Chart 22 : Reversing lights do not work but the
starter motor works.
yes
yes
Check/ensure continuity between track B of the 6 track connector and the reversing
lights. After the operation, does the fault persist?
Test the multifunction switch between tracks A and B on the 6 track connector,
Lever in R : R = 0 to 0,5
Lever in P/N/D/2/1 : R = infinity.
between the grey and green wires.
Are the measurements still incorrect?
yes
continuity between track A on the 6 track
no
If continuity is ensured, check the operation
After the operation, does the fault persist?
yes
computer side:
.
Do you note these values when testing?
no
Validate the no load and full load values for
23-249
no Correct
no
Turn the ignition off and ensure the
connector and the ignition switch.
of the switch.
yes
no
Replace the computer.
Erase the memory if M 4-3.
the E7J version*.
23
3DMXTT1.0