Bargraph 1 - Rh Extinguished Or No Communication With The Computer - Renault Clio Workshop Repair Manual

Fiches n 1
24 and 26
Fault finding using bargraph illumination
Check that the battery voltage is > 10.5 V.
Check that the fuse of the automatic
After these checks, does the fault persist?
If the XR25 is connected directly
to the diagnostic socket, check that
the 3 track connector is correctly
connected between the diagnostic
Check/ensure the continuity of the line
between the 3 track connector and the
Check/ensure that track 2 of the
diagnostic socket is earthed and the
presence of battery + on track 6.
- Earth through wire on multifunction
switch.
- + after ignition on track F of the 6
track connector on the wiring side.
Replace the computer if the fault persists
after checking the wiring on the 6 track
connector. Erase the computer memory.
On E7J* version, erasing the memory
requires the no load and full load values to
* And vehicles with load information supplied by the injection computer.
(Without load potentiometer specific to the automatic transmission).
AUTOMATIC TRANSMISSION
BARGRAPH 1 RH EXTINGUISHED OR NO
COMMUNICATION WITH THE COMPUTER
transmission is not blown.
yes
socket and the computer
diagnostic socket.
After this operation,
does the fault persist?
yes
Check the computer feed
is correct:
After checking/repairing,
does the fault persist?
yes
be reprogrammed.
no
no
no
23-208
Success
Success
Success
2DMXTT1.0
23