Renault Clio Workshop Repair Manual page 204

Fiche n 26
C C C C O O O O M M M M M M M M A A A A N N N N D D D D M M M M O O O O D D D D E E E E
Command mode is used to statically test the ope-
ration of:
- the air conditioning compressor clutch cut-off
relay
- the solenoid valves
.
Connect the XR25.
Turn the selector to S8.
92655R3
Turn on the ignition.
Engine not running, vehicle stationary, on the
keypad enter the code of the automatic transmis-
sion.
D
AUTOMATIC TRANSMISSION
Additional tests
1 4
The following will appear on the display:
On the keypad enter:
G
The following will appear on the display:
Bargraphs 13RH, 17RH and 17LH will illuminate
when the components are tested.
At the end of the test, the XR25 makes a noise.
The following will appear on the display:
then:
If faults have been detected, bargraphs 7RH
and/or 8RH and/or 8LH will illuminate.
Locate the fault using the fault finding charts.
23-202
23
0 1 *