5Th Gear Housing: Removal - Refitting - Renault Duster 2007 Manual

5th gear housing: Removal - Refitting

JR5
Equipment required
oil recovery tray
Tightening torquesm
5th gear housing bolts
front left-hand axle sub-
frame tie-rod bolt
the nut of the front left-
hand axle subframe tie-
rod
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair:
- (see M a nual gearbox: Precautions for the
repair) ,
- see Vehicle: Precautions for repair (01D,
Mechanical introduction).
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine undertray bolts,
- the engine undertray,
- the front left-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres).
a Drain the gearbox (see 21A, Manual gearbox,
Manual gearbox oils: Draining - Filling, page
21A-1) (21A, Manual gearbox).
a Remove the front left-hand wheel arch side liner.
MANUAL GEARBOX
25 N.m
21 N.m
21 N.m
21A-18
a Remove:
- the bolt (1) mounting the power-assisted steering
pipe on the gearbox,
- the bolt (2) mounting the power-assisted steering
pipe on the gearbox support.
a Loosen the nut (3) on the tie rod of the front left-hand
axle subframe.
a Remove the bolt (4) from the tie rod of the front left-
hand axle subframe.
a Move the tie rod away from the front left-hand axle
subframe.
21A
145884
144756