Bargraph 10 Rh And/Or Lh Illuminated - Renault Clio Workshop Repair Manual

Fiches n
24 and 26
Fault finding using bargraph illumination
Program the no load and full load values (only on version E7J*).
Failure to program (bargraph 10 remains illuminated after programming) is normal if the
values programmed are not between 1.37 and 37.5 % in the full load position and/or greater
than 60 % in the no load position.
Validate the full load position by pressing on the
accelerator pedal for 5 seconds, ignition on:
- bargraph 9 illuminates.
- bargraph 10 RH extinguishes.
Release the accelerator pedal and wait for at least 5
seconds before switching off the ignition.
Is bargraph 10 extinguished?
Is bargraph 4 also illuminated?
* And vehicles with load information supplied by the injection computer.
(Without load potentiometer specific to the automatic transmission).
AUTOMATIC TRANSMISSION
BARGRAPH 10 RH and / or LH ILLUMINATED
no
no
Is the throttle valve 100 % open when the accelerator
no
Adjust the accelerator control
and validate the no load and
full load values.
yes
yes
is pressed down fully?
Check the potentiometer on
the injection side.
Validate the no load and full
23-221
Success
Deal with bargraph 4.
yes
load values.
23
2DMXTT1.0