Final Drive Assembly (Mb); Separating The Casings; Converter And Differential Casing - Renault Clio Workshop Repair Manual

T T T T I I I I G G G G H H H H T T T T E E E E N N N N I I I I N N N N G G G G T T T T O O O O R R R R Q Q Q Q U U U U E E E E S S S S ( ( ( ( i i i i n n n n d d d d a a a a N N N N . . . . m m m m ) ) ) )
Bolts ( 8 mm) for assembling the gear
section casing on the final drive casing
Bolts ( 8 mm) for assembling the
converter and differential casing on
the separator housing
Bolts for mounting stator shaft
R R R R E E E E M M M M O O O O V V V V A A A A L L L L
The parts must be removed and handled on a
bench with a padded top (rubber or thick plastic).
•

Separating the casings

Remove:
- the converter,
- the oil pump driveshaft.
Separate the final drive casing from the gear sec-
tion casing.
R R R R E E E E M M M M E E E E M M M M B B B B E E E E R R R R T T T T H H H H E E E E N N N N U U U U T T T T A A A A T T T T T T T T H H H H E E E E L L L L E E E E F F F F T T T T H H H H A A A A N N N N D D D D
S S S S U U U U N N N N W W W W H H H H E E E E E E E E L L L L E E E E N N N N D D D D . . . .
AUTOMATIC TRANSMISSION

Final drive assembly (MB)

S S S S P P P P E E E E C C C C I I I I A A A A L L L L T T T T O O O O O O O O L L L L I I I I N N N N G G G G R R R R E E E E Q Q Q Q U U U U I I I I R R R R E E E E D D D D
B. Vi. 945 Mandrel for fitting sunwheel seal
B. Vi. 946 Mandrel for fitting stop ring to
sunwheel
B. Vi. 947 Mandrel for fitting bearings in
separator housing.
B. Vi. 1402 Tool for centring converter seal
(from kit B. Vi. 1400-01).
2.5
2.5
2.5
88951R2
Separate the separator housing from the conver-
ter and differential casing.
•

Converter and differential casing

Remove the O-ring (29) from the sunwheel.
Tap the base of the lip seal (28) with a pin drift
and a small mallet so that it turns in its seat.
Once the seal is dislodged, remove it with a pair of
pliers, taking care not to damage the sunwheel
splines.
23-73
23
86374R
86031R