Chart 47: No Reverse Gear When Warm Or Bang When Engaging Reverse When Reaccelerating; Chart 48: No 1St Gear Hold After Operation On Hydraulic Distributor; Chart 49: Cannot Change 2/3 In Full Load But Can Change In No Load - Renault Clio Workshop Repair Manual

AUTOMATIC TRANSMISSION
23
Fault finding aid
Chart 47 : No reverse gear when warm or bang
when engaging reverse when reaccelerating.
If the warning light is operational and it remains extinguished when there is a
fault, check the condition of the engine and transmission assembly mounting no Correct
pads. Check and if necessary adjust the idle speed, selector lever in position D.
After the operation, does the fault persist?
yes
Check the condition of the seals for the piston and the piston mounting for F1.
Replace any parts deemed to be faulty.
Chart 48 : No 1st gear hold after operation on
hydraulic distributor.
If the warning light is operational and it remains extinguished when there is a
fault, the fault is certainly due to the absence of the sequence valve spring in the
hydraulic distributor (reference mark VS).
Chart 49 : Cannot change 2/3 in full load but can
change in no load.
If the warning light is operational and it remains extinguished when there is a
fault, check the adjustment of the accelerator cable.
Also check the condition of the air filter.
3DMXTT1.0
23-268