Renault Clio Workshop Repair Manual page 71

Fit clip (E) to the sealed connector (T) and connect
it.
Refit the hydraulic distributor and its two seals
and plate. Tighten the hydraulic distributor bolts
to the correct torque in the order given (see
"Hydraulic distributor" section).
Fit a new strainer.
Fit the sump and tighten the bolts to a torque of
0.6 daN.m (except on ML).
AUTOMATIC TRANSMISSION
Gear section casing
85661R1
85596S
A A A A D D D D J J J J U U U U S S S S T T T T I I I I N N N N G G G G T T T T H H H H E E E E E E E E N N N N D D D D F F F F L L L L O O O O A A A A T T T T
The end float is the operating clearance of the
gear section of the automatic transmission.
The average clearance (J) must be 0.8 mm.
The end float is adjusted by shim (K) which is a
ground shim.
The adjustment is made in two stages.
23-69
23
85615R1