Renault Clio Workshop Repair Manual page 147

Fiche n 1
Fault finding using bargraph illumination
Check that the battery voltage is > 10.5 V.
Check that the fuse of the automatic
After these checks, does the fault persist?
Check the 2 track connector connecting the
diagnostic socket and the computer is
correctly connected. (If the vehicle does
not have a diagnostic socket, check the
special wiring is correctly connected: red
terminal to battery +, black terminal to
battery - and green terminal to fault
Check/ensure the continuity of the line
between the 2 track connector and track 7
Check/ensure that track 2 of the
diagnostic socket is earthed and the
presence of battery + on track 6.
After this operation, does the fault persist?
- Earth through wire on multifunction
switch (earth on track E of the 6 track
connector on the first version) .
- + after ignition on track F of the 6
track connector on the wiring side.
Replace the computer if the fault persists
after checking the wiring on the 6 track
connector. Erase the computer memory if
AUTOMATIC TRANSMISSION
BARGRAPH 0 RH EXTINGUISHED OR NO
COMMUNICATION WITH THE COMPUTER
transmission is not blown.
yes
warning
light output).
of the diagnostic socket.
yes
Check the computer feed
is correct:
After checking/repairing,
does the fault persist?
yes
an M4-3 computer is fitted.
no
no
no
23-145
Success
Success
Success
1DMXTT1.0
23