Reverse Gear Switch: Removal - Refitting - Renault Duster 2007 Manual

Reverse gear switch: Removal - Refitting

JR5
Special tooling required
Bvi. 1934 Socket for removing/refitting
reverse gear switch
Tightening torquesm
reverse gear switch
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove the engine undertray.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the connector (1) from the reverse gear
switch.
MANUAL GEARBOX
23 N.m
132991
21A-26
a Remove the reverse gear switch (2) using the (Bvi.
1934).
Note:
Seal the housing of the reverse gear switch while
replacing the part.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Apply some SILICONE ADHESIVE SEALANT (see
Vehicle: Parts and consumables for the repair)
(04B, Consumables - Products) to the threading of
the reverse gear switch.
a Refit the reverse gear switch using the (Bvi. 1934).
a Torque tighten the reverse gear switch (23 N.m).
a Connect the reverse gear switch connector.
II - FINAL OPERATION
a Fill the gearbox (see 21A, Manual gearbox, Manu-
al gearbox oils: Draining - Filling, page 21A-1) .
a Refit the engine undertray.
21A
132990